At the end of the day, it's about your peace of mind. I don't have any statistical data on push-fit connector failures, so have no way to prove if they're better or worse than backstab terminals.There should be no problem removing the connector, and using twist-on wire connectors instead. As long as you use the proper sized twist-on wire connector, and make a solid connection. However, I'm sure loads of people do it, and it's doubtful that an inspector would ever fail an inspection because of it. And is technically against National Electrical Code, since you're not installing the fixture according to the manufacturer's installation instructions.
Which technically probably voids the UL listing. Technically, removing them is modifying a factory assembly. Choosing between Ideal Push-In connectors vs WAGO connectors stumps many contractors due to their similarities, but one key difference is the lever direction on each connector’s outer housing. However, loads of folks still have a bias against these connectors, because of the poorly designed " backstabs" that proceeded them.Īs for removing the factory installed connectors. Push-in connectors are more expensive than wire nuts, and may initially challenge new users. These new connectors seem to be reliable, and don't appear to suffer the same failures as the old " backstab" terminals. These connectors make wiring the fixture easier, and are used by most installers. From light to advanced customization or a complete new design we will team up with you to design the optimal. It's very common for newer light fixtures especially recessed fixtures, to include " push-fit" connectors. Tailored solutions backed by in-depth research. Modern " push-fit" connectors are a bit different, and are designed with past failures in mind. The "backstab" terminals the internet rants about, were poorly designed terminals that were built into devices (receptacles, switches, etc.). I understand your concern, but you're probably overreacting. If you want to remove the factory installed connector, because you've read all over the internet about how bad "backstab" terminals are. Technically, probably not.īut let's talk first about why you want to cut off the quick connect fitting.
0 kommentar(er)
